Directed Electronics Hornet 564T Przewodnik Instalacji Pobierz pdf (Strona 22)

2222

This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be used to

pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the arm wire.

Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the dash-

board. In most diesels the wire is negative (ground turns on the bulb) and the GRAY/BLACK wire can be directly

connected to the wire in the vehicle. If the vehicle uses a positive wire (12V to turn on the bulb) a relay must

be used to change the polarity. (See

Finding the Wires You Need

section of this guide.) Here are some common

colors of this wire:

■ Chevrolet and GMC trucks - Light blue or dark blue

■ Ford Trucks - Black/pink

■ Dodge Ram Trucks - Orange/black or black/orange

NNOOTTEE!!

A 1-amp diode must be installed in line on the factory wire between the wait-to-start indi-

cator and the ECM. (See the following diagram for details.)

HH22//55 GGRREEYY//BBLLAACCKK ((--)) ddiieesseell wwaaiitt--ttoo--ssttaarrtt bbuullbb iinnppuutt

HH22//44 GGRREEEENN//WWHHIITTEE ((--)) ffaaccttoorryy aallaarrmm rreeaarrmm

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Brak uwag

Directed Electronics Hornet 564T Przewodnik Instalacji Strona 22