Directed Electronics Matrix 1 Przewodnik Instalacji Pobierz pdf (Strona 5)

IMPORTANT! Never interrupt any wire other than the starter

wire.

H1/2 WHITE (+/-) light flash output

As shipped, the H1/2 WHITE wire should be connected to the (+) parking

light wire. If the light flash polarity jumper is moved to the (-) position (see the

Programming Jumper section of this installation guide), this wire supplies

a (-) 200 mA output.

NOTE: For parking light systems that draw 10 amps or more, the jumper

must be switched to a (-) light flash output (see the

Programming Jumpers

section of this guide). P/N 8617 or a standard automotive SPDT relay must

be used on the H1/2 light flash output wire.

IMPORTANT! DO NOT connect this wire to a negative vehicle

light flash wire before changing the programming jumper to

the negative polarity position or damage to vehicle light circuit

may occur.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Brak uwag

Directed Electronics Matrix 1 Przewodnik Instalacji Strona 5