Directed Electronics D800 Instrukcja Obsługi Strona 12
- Strona / 56
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Step 3: Repeat Step 2 for the other side of the module.
Step 4: If you purchased a Sponsor Panel, Model SP-A, the sponsor mod-
ule mounts above the top module as shown in Figure 11. Place the sponsor
module above the top module. Overhang one end of the sponsor module
and slide the flange extrusion into the top channel of the module. Repeat
for the other side.
This operation is similar to the “one-line module” mounting. Be sure to
place the scoreboard modules right side up to avoid mounting the modules
upside down.
Step 1: Place the bottom module on its back over a flat raised surface.
Note: The bottom module’s interconnect cable to the top module
and the serial number are located in the lower right side of the
module as you face the front of the unit.
Step 2: Align the portable leg’s bottom pre-drilled hole with the hole in
the bottom module’s endplate. Slide the legs from the portable stands
through the module’s formed endplates and slide the quick connect pins
through.
Step 3: Align the portable leg’s top pre-drilled hole with the hole in the
top module’s endplate and slide the quick connect pins through.
Step 4: Slide the black ABS plastic sign into the channel between the top
and bottom module.
Note: If you purchase a sponsor panel, Model SP-A, refer to Step 4
“One-Line Module.”
If you purchase the optional caddy with wheels, Module CAD-P, first
mount the portable legs to the scoreboard following the instructions pro-
vided. Then retrofit the caddy to the assembled scoreboard.
Figure 12: CAD-P Caddy
Two-Line Module
Optional Caddy
3-2
- Scoreboard 1
- Installation 1
- Table of Contents 3
- 7 Service 4
- Optional Accessories 9
- Scoreboard Mounting 11
- Two-Line Module 12
- Optional Caddy 12
- CAD-P Assembly 13
- Instructions 13
- Mounting Using Pole Mounts 14
- (Center to Center) 15
- Table: Pole Placement 15
- Mounting Using Wall Mounts 17
- Fence Mounting 20
- Introduction 21
- Ground Rods 22
- Conductors 22
- Conductor Routing 25
- Control Board 27
- Selector Switch for 30
- Control Boards 30
- Electrical Power Requirements 31
- Speaker(s) 31
- Operator’s (Keyboard) Console 31
- One Scoreboard 32
- Figure 37 34
- Power Requirements 35
- External Battery Operation 36
- Correct Use of 37
- ON/OFF Switch 37
- Trouble Shooting-Audio 40
- Trouble Shooting-Digits 42
- Segment Repair and 44
- Maintenance 44
- Testing Digit Coils 44
- How to Remove a Digit 45
- Trouble Shooting-Data Cable 48
- Trouble Shooting-Speaker 50
- To Charge the Battery 51
- To Replace the Battery 51
- Long-Term 52
- Battery Storage 52
- Figure 51 53
Powiązane produkty i podręczniki dla Wzmacniacze audio Directed Electronics D800
(8 strony)Cobra Electronics 15 BAND XRS 9770 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Sport und Erholung Cobra Electronics 15 BAND XRS 9770.
Wir stellen 1 PDF-Handbücher Cobra Electronics 15 BAND XRS 9770 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Komentarze do niniejszej Instrukcji