Directed-electronics BOA 165B Instrukcja Użytkownika

116655BB➤OOwwnneerr’’ss//IInnssttaallllaattiioonn GGuuiiddee

7© 2004 Directed Electronics, Inc.start module must be removed or properly reinstalled so thatthe vehicle does not start in gear. OOPPEERRAATTIIOONN

8© 2004 Directed Electronics, Inc.pprriimmaarryy hhaarrnneessss ((HH//11)),,88--ppiinn ccoonnnneeccttoorrrreellaayy wwiirreess 66--ccoonnnneecctt

9© 2004 Directed Electronics, Inc.uussiinngg LLEEDD tteesstt pprroobbeeTo use the LED test probe:1. Remove the protective cover off the probe tip.

10© 2004 Directed Electronics, Inc.iinnssttaallllaattiioonnBe sure to read this section thoroughly and view the Do-It-Yourself Installation CDROM vide

11© 2004 Directed Electronics, Inc.step 1Ground WireThe BLACK (H1/5) wire on the main 8-pin harness is ground.This wire should be connected to a clean

12© 2004 Directed Electronics, Inc.step 2Constant Power and Ignition wiresAlmost all power and ignition wires can be found behind the keycylinder unde

13© 2004 Directed Electronics, Inc.Once the constant power wire (or wires) has been identified, solderthe two thick RED wires from the control module

14© 2004 Directed Electronics, Inc.If the vehicle requires more than one ignition as per the Web siteinformation follow the same test procedure and so

15© 2004 Directed Electronics, Inc.Now that the accessories have been located, find the wiresuspected to be the starter wire according to the web info

16© 2004 Directed Electronics, Inc.step 4Safety Shutdown WiresWith all ignition wires properly connected, find the appropriatesafety shutdown wires. T

i© 2004 Directed Electronics, Inc.lliimmiitteedd lliiffeettiimmee ccoonnssuummeerr wwaarrrraannttyyDirected Electronics, Inc. (hereinafter "Di

17© 2004 Directed Electronics, Inc.Installing the hood pin switch requires drilling a ¼-inch hole in themetal lip under the hood. Choose a location th

18© 2004 Directed Electronics, Inc.temporarily (i.e., for service on the vehicle or when parking in anenclosed area). This switch is to be mounted in

19© 2004 Directed Electronics, Inc.Using the web information on the vehicle, locate the suspectedwire and place the red lead of the LED tester to a co

20© 2004 Directed Electronics, Inc.step 6Engine monitoring (voltage—default setting)During remote start the system will need to know if the engineis r

21© 2004 Directed Electronics, Inc.Engine monitoring (tachometer—optional)Identify the suspect wire according to the web information.Place the black l

22© 2004 Directed Electronics, Inc.hood pin wire and pull the wire through the grommet takingextra care to keep it away from any moving parts or anyth

23© 2004 Directed Electronics, Inc.it. Probe the suspect wire with the LED tester. While probingthe wire, place the key in the drivers door cylinder.

24© 2004 Directed Electronics, Inc.dealer. The majority of transponder-based immobilizer systemscan be bypassed using the 555U/556U immobilizer bypass

25© 2004 Directed Electronics, Inc.2.PPrrooggrraamm..After 5-seconds, press and hold the buttonon the transmitter, until—(see step 3).3.PPaarrkkiinngg

26© 2004 Directed Electronics, Inc.ttrraannssmmiitttteerr ffuunnccttiioonnssThe receiver uses a computer-based learn routine to learn thetransmitter

ii© 2004 Directed Electronics, Inc.OR IN CONNECTION WITH THE INSTALLATION, USE, IMPROPER USE, ORINABILITY TO USE, THE PRODUCT, EVEN IF THE PARTY HAS B

27© 2004 Directed Electronics, Inc.CCoonnttrrooll MMoodduullee PPrrooggrraammmmiinnggDepending on the vehicle, use the following data with theinstru

28© 2004 Directed Electronics, Inc.uussiinngg yyoouurr ssyysstteemmwarning! safety firstThe following safety warnings must be observed at all times:

29© 2004 Directed Electronics, Inc.feature of the vehicle periodically checked, wherein the vehiclemust not remotely start while the car is in gear. T

30© 2004 Directed Electronics, Inc.remote start This feature allows you to remotely start your vehicle. Thismakes it possible to warm up the engine, a

31© 2004 Directed Electronics, Inc. The shutdown toggle switch is put into the ON position. The pre-programmed run time has elapsed (12-minutes). T

32© 2004 Directed Electronics, Inc.3. The vehicle will start every 3 hours, it will run for a periodof 12-minutes or until a shutdown input is trigger

33© 2004 Directed Electronics, Inc.3. Do not step on the brake.4. Press the button twice. The parking lights will flashtwice to confirm pit stop mode

34© 2004 Directed Electronics, Inc.ssyysstteemm eexxppaannssiioonn iitteemmssThe following item can be added to the system:➤ Starter Kill➤ Window Au

35© 2004 Directed Electronics, Inc.Has the tach wire been learned? See the Tach Learningsection of this guide.Is the tach wire receiving the correct i

36© 2004 Directed Electronics, Inc.starter side wire of the vehicle.4. Does the vehicle have an immobilizer? Some immobilizersystems will not allow t

1© 2004 Directed Electronics, Inc.ttaabbllee ooff ccoonntteennttsslliimmiitteedd lliiffeettiimmee ccoonnssuummeerr wwaarrrraannttyy.. .. .. ..

37© 2004 Directed Electronics, Inc.wwiirriinngg qquuiicckk rreeffeerreennccee gguuiiddeeANTENNABLUE WIRE LOOP -CUT FOR DIESEL VEHICLESRED (+) 30A h

38© 2004 Directed Electronics, Inc.nnootteess_________________________________________________________________________________________________________

CCuutt aalloonngg ddootttteedd lliinnee aanndd ffoolldd ffoorr aa qquuiicckk aanndd eeaassyy rreeffeerreennccee ttoo kkeeeepp iinn yyoo

The company behind this system is Directed Electronics, Inc.Since its inception, Directed Electronics has had one purpose, to provide consumers withth

2© 2004 Directed Electronics, Inc.

3© 2004 Directed Electronics, Inc.wwhhaatt iiss iinncclluuddeedd➤ Control Module➤ One 4-Button Transmitter➤ 8-Pin Main H/1 Harness➤ 6-Relay Wires➤ S

4© 2004 Directed Electronics, Inc.iimmppoorrttaanntt iinnffoorrmmaattiioonnCongratulations on the purchase of your remote start system. Thissystem wi

5© 2004 Directed Electronics, Inc.fcc/id noticeThis device complies with Part 15 of FCC rules. Operation issubject to the following conditions: (1) Th

6© 2004 Directed Electronics, Inc.transmitters to assure that the system does not uninten-tionally remote start the vehicle.4.TTHHEE UUSSEERR MMUU