Directed Electronics 335912 359D Przewodnik Instalacji Strona 44
- Strona / 57
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
41
© 2004 directed electronics, inc.
arming diagnostics
If the security system is armed at the same time that an input is
active (such as a door opening or sensor triggering), you will hear
one siren chirp to indicate arming and a second siren chirp to indi-
cate Bypass Notification. A Bypass Notification chirp means that
the security system ignores the input that was active when the
system was armed, until that input ceases. Three seconds after that
input ceases, the security system will resume normal monitoring.
For example, if your vehicle has an interior light exit delay and you
arm your security system before the interior light turns off, you
may hear a second Bypass Notification chirp. Once the light turns
off, however, the security system resumes normal monitoring.
disarming diagnostics
Extra chirps that are heard when disarming the system are the
Tamper Alert. If four chirps are heard when disarming the
system, then the security system was triggered in your absence. If
five chirps are heard when disarming the system, a zone was trig-
gered so many times that the Nuisance Protection Circuitry
™
has
bypassed that zone. In either case, the status LED will indicate
which zone was involved (see
Table of Zones
section). The secu-
rity system will retain this information in its memory and chirp
four or five times each time it is disarmed, until the next time
that the ignition is turned on.
➜
note: Bypass Notification does not occur when the sys-
tem is in Silent Mode or if the notification chirps have
been programmed off by the installer.
➜
- MMooddeell 556644TT 1
- LCD 2-way configuration 6
- Tested to Comply 11
- AAuuddiibbllee 19
- Command Page 23
- Page Recognition Mode 23
- Standard Remote 27
- Configurations 27
- Table of Zones 29
- Location of Valet 32
- To enter or exit Valet 34
- Mode using the remote: 34
- To remote start the vehicle: 35
- ➤ The brake pedal is pressed 36
- ➤ The hood is opened 36
- To perform Valet 37
- Take-Over: 37
- System Status Chirps 43
- (Number of DEALER-INSTALLED 46
- ➤ Power Saver in Valet 49
- ➤ Panic mode 50
- ➤ Forced passive arming 50
- ➤ Full trigger response 51
- Audio Sensor: 52
- Backup Battery: 52
- Hood Lock: 52
- Field Disturbance Sensor: 52
- Power Locks: 53
- Power Trunk Release: 53
- Power Window Control: 53
- Mobile Video: 53
- Warning Zone Response: 55
- QUICK REFERENCE GUIDE 56
- G564T 07-04 57
Powiązane produkty i podręczniki dla Zdalne rozruszniki Directed Electronics 335912 359D
(14 strony)
(20 strony)
(50 strony)Panasonic KXTG5671 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Telefony Panasonic KXTG5671.
Dostarczamy 1 pdf podręczników Panasonic KXTG5671 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Komentarze do niniejszej Instrukcji