Directed Electronics 737T Instrukcja Właściciela

ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ®Owner’s ManualC356BEEStereo Integrated Amplier

A MC INPUT: Input for a Moving Coil phono cartridge. Connect the twin RCA lead from your turntable to this input if you are using a Moving Coil cartri

USING THE SR 8 REMOTE CONTROLThe SR 8 remote control handset handles the key functions of the C 356BEE as well as other NAD Stereo Receivers, Integrat

CD PLAYER CONTROL (for use with compatible NAD CD Player): Set the DEVICE SELECTOR to “CD” in order to gain access to these buttons. Some of the contr

USING THE SR 8 REMOTE CONTROL LIBRARYThe SR 8 can store a dierent library of default NAD codes for each of its DEVICE SELECTOR “pages.” If the origin

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONSNo sound. • Mains power cord unplugged or power not switched ON.• Check if mains power cord is plugged i

PREAMPLIFIER SECTIONLINE LEVEL INPUT, PRE OUT THD1 20 Hz – 20 kHz, CCIF IMD, SMPTE IMD, DIM 100 <0.005 % at 2 V out Signal-to-Noise Ratio >1

PHONO SECTION (WITH OPTIONAL PP 375 INSTALLED)MM/MC IN, PRE OUT Input impedance - MC 100 ohms (R) 180 pF (C) MM 47 kohms (R) 180 pF (C) In

www.NADelectronics.com©2010 NAD ELECTRONICS INTERNATIONALA DIVISION OF LENBROOK INDUSTRIES LIMITEDAll rights reserved. NAD and the NAD logo are tradem

Our C 356BEE DAC with the new MDC DAC built in, symbolises NAD’s desire for continual improvement—even on an award-winning design. We have rened ou

LINE IN, SPEAKER OUT Continuous output power into 8 Ω and 4 Ω (Stereo) THD* 20Hz - 20kHz, CCIF IMD, SMPTE IMD, DIM 100 Clipping Power IHF Dynamic

SAVE THESE INSTRUCTIONS FOR LATER USE.FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON THE AUDIO EQUIPMENT.1 Read instructions - All the safety and oper

19 Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualied service personnel under the following conditio

NOTES ON ENVIRONMENTAL PROTECTIONAt the end of its useful life, this product must not be disposed of with regular household waste but must be returned

INTRODUCTIONGETTING STARTEDUNPACKING AND SETUPWHAT’S IN THE BOXPacked with your C 356BEE you will nd:• The SR 8 remote control with 2 (two) AA batte

IDENTIFICATION OF CONTROLSFRONT PANEL1 STANDBY BUTTON: With the rear panel POWER switch set to ON position, press this button to switch ON the C 356BE

8 INPUT SELECTORS: These buttons select the active input to the C 356BEE and the signal sent to the loudspeakers, headphones and the PRE OUT sockets.

1 RS-232: Connect this interface using RS-232 serial cable (not supplied) to any Windows® compatible PC to allow remote control of the C 356BEE via co

9 TAPE 2 IN/OUT: Connections for analog recording and playback to a tape recorder of any type. Using twin RCA-to-RCA leads, connect the left and righ