Directed Electronics D2400 Instrukcja Użytkownika Pobierz pdf (Strona 7)

The following procedure covers using the AN/CYZ-10 with CT3 software to

load an orderwire key in position F2. See TM 11-5820-1130-12&P for other

devices.

NOTE: Do not connect fill device before power-up of radio set.

NOTE: If display shows the message “COMSEC Alarm," press ESC to clear

the message. Then press ENT or PTT to clear the alarm.

1. AN/CYZ-10 in platform Manual mode.

a. After loading COMSEC keys in F1 on

AN/PSC-5, set mode switch on AN/PSC-5 to F2

and AN/CYZ-10 will return to the select location

menu.

F2: FILL ORDERWIRE

KEYS: _________

LOAD: 1

b. Page-up or down to select Key and press ENT.

NOTE:

Orderwire Key #’s Satellite Footprint NCTAMS

1 and 2 CONUS & IO LANT & NCTS GUAM

3 and 4 LANT and PAC PAC and EURCENT

c. Select fill location (1-4) on AN/PSC-5.

d. Arrow down on AN/CYZ-10.

e. Press ENT on AN/PSC-5 to initiate key fill.

f. The AN/PSC-5 display will indicate “Key Filled." And the numbered position

where it is loaded. If “Key Fill Failure," check equipment, then repeat

steps b - e.

2. AN/CYZ-10 in key management mode.

a. After loading COMSEC keys in F1 on AN/PSC-5, set mode switch on

AN/PSC-5 to F2 and AN/CYZ-10 will return to the select location menu.

b. Select XMIT and press ENT.

c. Select KEY and press ENT.

LOAD ORDERWIRE KEY

1 2 3 4 5 6 7 8 9 10 11 12 ... 71 72

Brak uwag

Directed Electronics D2400 Instrukcja Użytkownika Strona 7