Directed Electronics Valet 561T Przewodnik Instalacji Pobierz pdf (Strona 38)

3388

■

TThhee vveehhiiccllee wwiillll ssttaarrtt aanndd rruunn oonnllyy ffoorr aabboouutt 1100 sseeccoonnddss..

1. Is the remote start programmed for voltage sense? Try programming the unit for low voltage reference. If this

does not work, a tach wire should be used.

2. Check diagnostics.

■

DDiieesseell vveehhiiccllee ddooeess nnoott wwaaiitt ttoo ssttaarrt

t..

1. Is the GRAY/BLACK wire connected to the wait-to-start wire of the vehicle?

2. Check the polarity of the wait-to-start wire. (See the

Finding the Wait-to-Start Bulb Wire For Diesels

section

of this guide.)

3. If wiring a negative wait-to-start bulb, make sure that a diode has been placed in line on the factory wire

between the vehicle’s ECM and the wait-to-start bulb. (See wiring description for the

H1/6 GRAY/BLACK (-)

Diesel Wait-To-Start Bulb Input

of the

Primary Harness Wire Connection Guide

1 2 ... 33 34 35 36 37 38 39

Brak uwag

Directed Electronics Valet 561T Przewodnik Instalacji Strona 38